Check Filter Feature - Frigidaire 220213A196 Use And Care Manual

Air Conditioner Features
(continued)

CHECK FILTER FEATURE:

CLEAN AIR FEATURE
(on some models):
REMOTE SENSING/FOLLOW ME FEATURE
:
(on some models)
SET TEMP.
ON
OFF
FAN SPEED
SENSING/FOLLOW ME
Note: This feature can be activated from the remote control ON L Y , the unit must be in a cooling mode.
T o activate the remote sensing feature, point the remote contro l towards the unit and press the remote sensing button. Next, use the
buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself). The LIGH T on
the unit control will pulse to indicate it received the signal. The LIGH T on the remote contro l will pulse each time it sends a signal. It will con-
tinue to send this signal until the feature is deactivated by pressing the remot e sensing button. If the unit does not receive the remote sensing
signal during an y 3 m in u te interval , the u n i t will b e e p to i n di c a t e the remote sensing mode has ended. The display on the remot e control indicates
the temperature at the remote ON L Y . The unit display indicates the set temperature.
LIGHT On
DO THIS:
PRESS
CLEAN AIR
BUTTON
DO THIS:
PRESS REMOTE
BUT T ON ON
NOTE: Unit display shows "set" temperature
YOU WILL SEE:
Note: This feature is a reminder to clean the Air Filter (See Care
and Cleaning) for more efficient operation and cooling. The LED
(light) will illuminate after 250 hours of operation. To reset after
cleaning the filter, press the " Check Filter " button and the light
will go off.
YOU WILL SEE:
Note: When this feature is "ON", the electronic air purifier is
energized to remove pollen and impurities from the air. To cancel this
feature, press the Clean Air button (the LIGHT will turn off).
LIGHT pulsing On & Off intermittently.
9
DO THIS:
AFTER CLEANING
PRESS CHECK FILTER BUTTON
LIGHT On
ON
OFF
FAN SPEED
NOTE: Remote display
is actual temperature at
remote control only
SET TEMP.