Deep Reach Tool Attachment - Bissell LITTLE GREEN PROHEAT 50Y6 SERIES User Manual

Operations
cleaning with your little Green pRoheat
1. Turn the power/heater to the ON position.
Wait 30 seconds before use to allow the heater
to reach the proper temperature.
2. Hold the tool approximately 1" above the
soiled surface. Press the spray trigger to apply
the cleaning solution to the soiled area. Raise
the tool slighty to check for spray. When using
the Deep Reach Tool (select models), keep the
tool in contact with the carpet while spraying.
3. Using the brush on the tool, gently scrub
the area to be cleaned.
4. For thorough cleaning, spray additional
solution while the brush and suction are in
contact with the surface.
5. Apply downward pressure on the tool and
pull it toward you. The suction will remove the
dirt and cleaning solution. Continue until no
more dirt can be removed.
6. As a final step, use "drying strokes" (by not
pressing the spray trigger) to remove as much
liquid/moisture as possible. Repeat this step
as often as necessary.

Deep Reach tool attachment

select models only
1. Follow instructions 1-5 on page 6
"Getting ready".
2. set tool on stain and press the trigger to
spray solution onto the area to be cleaned.
3. slowly move the tool back and forth over
the soiled surface, keeping the tool in contact
with the carpet.
4. Release trigger and move tool slowly over
the soiled area to suction up water and dirt.
5. Continue to clean the area, working in small
sections, until no more dirt can be removed.
6. Remove tool from hose when finished.
Clean under warm water before storing.
Tips
» Deep cleaning stairs and high-traffic areas on
a regular basis helps prolong carpet life.
» Check upholstery stuffing before cleaning.
Colored stuffing may bleed through the fabric
when it becomes wet.
Keep spray away from face. Failure to do
so may result in personal injury.
1.
ImpoRtant
Check the manufacturer's tag before
cleaning upholstery. "W" or "WS" on the
tag means you can use your Little Green
ProHeat. If tag is coded with an "S" (with
diagonal strike-through), or says "Dry Clean
Only," do not proceed. If manufacturer's tag
is missing or not coded, check with your
furniture dealer.
3.
6.
» If a significant amount of water and solution
remains in the clean tank, your unit can be stored
with liquid in the clean tank.
www.bissell.com
WaRnInG
Power/Heater switch
5.
800.237.7691
7