Friedrich MW09Y3H Operating Manual page 5

Fig. 1 Indoor Unit
a-1 Operating Control Panel (Fig. 2)
a-2 MANUAL AUTO button
G
When kept on pressing the MANUAL
AUTO button for more than 10 seconds,
the forced cooling operation will start.
G
The forced cooling operation is used at
the time of installation.
Only for authorized service personnel's
use.
G
When the forced cooling operation
starts by any chance, press the START/
STOP button to stop the operation.
a-3 Indicator (Fig. 3)
a-4 Remote Control Signal Receiver
a-5 OPERATION Indicator Lamp (green)
a-6 TIMER Indicator Lamp (orange)
G
If the TIMER indicator lamp flashes when
the timer is operating, it indicates that a
fault has occurred with the timer setting
(See Page 15 Auto Restart).
a-7 COIL DRY Indicator Lamp (yellow)
a-8 Intake Grille (Fig. 4)
a-9 Front Panel
a-10 Air Filter
a-11 Airflow Direction Louver
a-12 Right-Left Louver
(behind Airflow Direction Louver)
a-13 Drain Hose
Fig. 5 Outdoor Unit
a-14 Intake Port
a-15 Outlet Port
a-16 Pipe Unit
a-17 Drain port (bottom)
Fig. 6 Remote Control Unit
b-1 Signal Transmitter
b-2 MODE button
b-3 MIN. HEAT button
b-4 SET TEMP. button (
b-5 COIL DRY button
b-6 SLEEP button
b-7 TIMER MODE button
b-8 FAN button
b-9 START/STOP button
b-10 ECONOMY button
b-11 SET button
b-12 SWING button
b-13 TIMER SET ( / ) button
b-14 CLOCK ADJUST button
b-15 TEST RUN button
G This button is used when installing the
air conditioner, and should not be used
under normal conditions, as it will cause
the indoor unit's thermostat function to
operate incorrectly.
G If this button is pressed during normal
operation, the indoor unit will switch to
test operation mode, and the Indoor
Unit's OPERATION Indicator Lamp and
TIMER Indicator Lamp will begin to flash
simultaneously.
G To stop the test operation mode, press
the START/STOP button to stop the air
conditioner.
b-16 RESET button
c-1 Remote Control Unit Display (Fig. 7)
c-2 Transmit Indicator
c-3 Fan Speed Display
c-4 SWING Display
c-5 Timer Mode Display
c-6 Clock Display
c-7 Temperature SET Display
c-8 ECONOMY Display
c-9 Operation Mode Display
c-10 COIL DRY Display
c-11 SLEEP Display
/ )
En-4