The First Wash Cycle - Hotpoint WDD 960 P Instructions For Use Manual

Table of Contents

Advertisement

As the colours of the wires in the lead may not corre-
GB
spond with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
Connect Green & Yellow wire to terminal marked E or
or coloured Green or Green & Yellow.
Connect Brown wire to terminal marked L or coloured
Red.
Connect Blue wire to terminal marked N or coloured
Black.
If a 13 amp plug (BS 1363) is used it must be fitted with
a 13 amp fuse, either in the plug or adaptor or at the
distribution board.
If you are in any doubt about the electrical supply to
your machine, consult a qualified electrician before use.
How to connect an alternative plug:
The wires in this mains lead are coloured in accordance
with the following code:
BLUE
BROWN
GREEN & YELLOW
GREEN &
YELLOW
BROWN
BLUE
Disposing of the appliance:
When disposing of the appliance please remove the plug
by cutting the mains cable as close as possible to the plug
body and dispose of it as described above.
!
The Washer-dryer should not be installed in an out-
door environment, not even when the area is sheltered,
because it may be very dangerous to leave it exposed to
rain and thunderstorms.
!
When the Washer-dryer is installed, the mains socket
must be within easy reach.
!
Do not use extensions or multiple sockets.
!
The power supply cable must never be bent or dange-
rously compressed.
!
The power supply cable must only be replaced by an au-
thorised serviceman.
Warning! The company denies all liability if and when
these norms are not respected.
4
NEUTRAL (N)
LIVE (L)
EARTH (E)
13 ampere fuse
CROSS-BAR
CORD GRIP

The first wash cycle

Once the appliance has been installed, and before you
use it for the first time, run a wash cycle with detergent
and no laundry, using the wash cycle
.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wdd 960 gWdd 960 aWdd 960 k

Table of Contents