Key Operator Code Change; Print Key Operator Programs List; Default Settings - Sharp AR-C260P Key Operator's Manual

DESCRIPTION OF PROGRAMS
I Key operator code change
This program is used to change the key operator
code.
The key operator must enter the key operator code
to access the key operator programs. Only one key
operator code number can be programmed. The
key operator code is initially set to "00000". It is
recommended that the key operator use this
program to change the key operator code after
accessing the programs with the initial code.
Display "KEY OPERATOR CODE CHANGE" as
indicated in the chart on page 29.
I Print key operator programs list
This program is used to print a list of the key
operator programs.
"PRINT KEY OPERATOR PROGRAMS LIST" is
displayed as indicated in the chart on page 29.
I System settings

Default settings

These programs are used to adjust the settings of
various printer functions.
G Disable notice page printing
This program is used to disable notice page printing.
Enable this program when you do not want the
machine to print the notice page explained in
"NOTICE PAGE PRINTING" on page 4-6 of the
Operation Manual (for printer).
"DISABLE NOTICE
displayed as indicated in the chart on page 29.
G Disable test page printing
This program is used to disable test page printing.
When the program is enabled, the Print list in the
custom settings cannot be printed. (See page 2-17
of the Operation Manual (for general information).)
"DISABLE TEST PAGE PRINTING" is displayed
as indicated in the chart on page 29.
20
PAGE PRINTING" is
G A4/LT auto select
When this program is enabled, the printer will
automatically substitute A4 paper if letter size
paper is not available when printing a letter-size
document. Note that letter size paper cannot be
automatically substituted for A4 paper.
"A4/LT AUTO SELECT" is displayed as indicated
in the chart on page 29.
NOTE
When letter size is specified for a document
attached to an E-mail that has been transmitted
from a foreign country and letter size paper is not
loaded in the printer, printing will not be possible
without operator intervention. However, if this
program is enabled, A4 paper will be automatically
substituted for letter size paper and printing will
take place without operator intervention.
G Delete hold data
Use this program to manually delete all print hold
jobs (jobs that are being held by the job retention
function explained on page 4-2 of the OPERATION
MANUAL (for general information).).
"DELETE HOLD DATA" is displayed as indicated
in the chart on page 29.
G Output method when memory full
When the internal memory becomes full, further
print data cannot be stored and the print data
stored to that point must be printed. This program
is used to set the condition for printing. The factory
default setting is "1 SET".
"OUTPUT METHOD WHEN MEMORY FULL" is
displayed as indicated in the chart on page 29.
G Bypass paper type
This program is used to select the default setting of
paper type to be loaded in the bypass tray. The
setting can be selected from "NONE", "PLAIN",
"HEAVY 1", "HEAVY 2", "TRANSPARENCY S" or
"TRANSPARENCY Q".
The factory default setting is "NONE".