Table of Contents
Advertisement
4.0 Log onto the web management interface
You will now access the web management graphical user interface (GUI) to configure the ipRocketLink using a
standard web browser (such as Internet Explorer or Netscape browser).
1.
At your PC, open a web browser and enter the IP address you assigned to the ipRocketLink's Ethernet LAN
port in step 2 of section
2.
Log in to the web management home page using the username superuser and the password superuser.
5.0 Connect the G.SHDSL Port
1.
Obtain single-twisted-pair cable with an RJ-11 plug connector at each end.
2.
Plug one end of the cable into the (yellow) RJ-11socket (labelled DSL) on the ipRocketLink Integrated
Access Device.
3.
Plug the other end of the cable into the RJ-11 wall socket that provides your G.SHDSL service.
4.
When a DSL link is established the front-panel WAN LINK LED will turn on.
Your ipRocketLink is equipped with one of the following serial WAN ports for connection to an NTU:
V.35 (M/34 or DB-25)—Model 3088FR/RIC/EUI
•
X.21 (DB-15)—Model 3088FR/RID/EUI
•
T1/E1(RJ-48C and dual BNC)—Model 3088FR/RIK/EUI
•
Connect the serial cable to the ipRocketLink serial port as follows:
1.
Attach the male connector of the serial cable to the female serial connector on the 3088FR.
2.
Attach the other end of the cable to the serial connector on local device's serial port.
ipRocketLink 3088FR Quick Start Guide
2.2 "Modify the IP address"
Figure 3.
ipRocketLink web management home page
6.0 Connect the serial port
on page 4.
5
Advertisement
Table of Contents
