Configuring Nat Static Protocol Entries - Patton electronics IPLink Series Software Configuration Manual

IPLink Software Configuration Guide
Example: Display NAT/NAPT configuration information
IPLink(pf-napt)[access]#show profile napt access
NAPT profile access:
--------------------------
STATIC NAPT MAPPINGS
Protocol Local IP
-------- ---------------
tcp 192.168.1.20
tcp 192.168.1.20
STATIC NAT PROTOCOL MAPPINGS
Protocol Local IP
-------- --------------- ---------------
ah 192.168.1.41
STATIC NAT MAPPINGS
Local IP
--------------- ---------------
192.168.1.40
STATIC NAPT RANGE MAPPINGS
Local IP Start
--------------- --------------- ---------------
192.168.1.10
STATIC NAT RANGE MAPPINGS
Local IP Start
--------------- --------------- --------------- ---------------
192.168.1.30
Configuring NAT static protocol entries
The following command adds a static NAT entry, which causes any packets of the specified protocol received
on the global side of the NAT to be forwarded to the host specified on the local side of the NAT.
node(pf-napt)[ name]#static { udp | tcp } local-ip local-port [ global-ip] [ global-port]
Mode: profile napt <pf-napt>
Step
1 [name](pf-napt)# static <protocol>
<local-ip-address> [<global-ip-
address>]
NAT/NAPT configuration task list
Local Port
-----------
80
23
Global IP
131.1.1.120
Global IP
131.1.1.20
Local IP Stop Global IP
192.168.1.19 131.1.1.15
Local IP Stop Global IP Start Global IP Stop
192.168.1.39 131.1.1.10
Command
12 • NAT/NAPT configuration
Global IP
---------------
0.0.0.0
131.1.1.3
131.1.1.15
Purpose
Adds a static NAT protocol entry
Global Port
-----------
80
23
136