Panasonic AJ-YBX200G Operating Instructions Manual page 4

Installation in AJ-HPX2000/2100
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire
or electric shock do not perform any servicing other than as directed in the operating instructions
unless you are qualified to do so.
1
Unscrew the two screws from the AJ-
YBX200G to remove the bracket.
Bracket
2
Be sure that the power of the AJ-HPX2000/
2100 is turned off.
3
Unscrew the six screws on the left side of
the AJ-HPX2000/2100 (on the left as
viewed from the front) to remove the side
panel.
E-3
4
Screws
No. 5
board
Flexible
Cables
5
Screws
Unlock the two parts to disconnect the two
flexible cables, and then remove the No.5
board.
Disconnect the cable from the No.5 board
4
removed in Step . In this operation, the
cable may become disconnected if pulled,
so remove it while holding the connector.
Cable
Connector
Unlock
Slot