CLCH-SVX01B-EN
17 Re-install the diameter seals or hub seal and tighten the
retaining screws.
18 Adjust the seals per the "Seal Adjustment" procedure.
19 Rotate the wheel in a clockwise direction to confirm that the
wheel rotates freely with a slight drag on the seals.
20 Re-install the bearing locking collar.
21 Rotate the collar by hand in the direction of wheel rotation.
22 Lock the collar in position by tapping the drift pin hole with a
hammer and drift.
23 Secure the collar in position by tightening the set screw.
24 Re-install the bearing access cover.
25 Apply power to the wheel and ensure that the wheel rotates
freely without interference.
Figure 9.
Wheel rotation
Seal Adjustment
1
Loosen the diameter seal adjustment screws and back the
seals away from the wheel surface (see Figure 9).
2
Rotate the wheel clockwise until two opposing spokes are
hidden behind the bearing support beam.
3
Using a folded piece of paper as a feeler gauge, position the
paper between the wheel surface and the diameter seals.
23