Assembly; Power Head Shaft/Lower Shaft Assembly; Front Handle Installation - Echo Pro Attachment Series PAS-266 Operator's Manual

PAS-266

ASSEMBLY

Power Head Shaft/Lower Shaft Assembly

Parts Required: PAS Attachment
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn
to lock-out position.
3. Remove vinyl cap from attachment drive shaft.
4. Remove cardboard spacer, if necessary.
5. Carefully fit attachment drive shaft assembly into coupler (B)
to decal assembly line (C), making sure that the inner lower
drive shaft engages the square upper drive shaft socket.
Note: Lower bearing housing and head assembly must be in
line with the engine.
6. Rotate locator pin (A) 1/4 turn clockwise to engage lower
shaft hole. Insure locator pin is fully engaged by twisting
lower drive shaft. Locator pin should snap flush in coupler.
Full engagement will prevent further shaft rotation.
7. Secure lower shaft assembly to coupler by tightening
clamping knob (D).

Front Handle Installation

Note: Label shows minimum spacing for front handle location
1. Position front handle for comfortable operation and secure
screws.
X7502026902
© 4/2013 ECHO Inc.
D
C
MIN
SPACING
ASSEMBLY
B
A
13