Advertisement
0
0
0
-5
-20
-35
S I X - H I G H " F E S T I V A L "
K F 8 6 0 C O N F I G U R A T I O N
Typical Uses: Festivals, large sheds
Coverage: +2 degrees to -60 degrees
Bumper Bar Trim Height (nominal): 27 ft
Splay: The boxes are aimed 0, 0, 0, -5, -20, & -35 degrees, so
the boxes should be rigged with 0 degree (top to second box),
0 degree (second to third box), 5 degree (third to fourth box),
15 degree (fourth to fifth box), and 15 degree (fifth to sixth
box) splays.
Aiming: The cluster should be aimed so that the top box
points at the highest/farthest seat or straight out for festivals.
This configuration is tuned for a 400 ft throw to the farthest
seat. The response falls off quickly above horizontal.
Processors: One processor should drive the upper four boxes.
This processor is referred to as "main" in the settings.
A second processor should drive the two lowest boxes.
This processor is referred to as "downfill" in the settings.
NOTE: This is different from all of the smaller rigs, which
treat only the one bottom box as "downfill".
• For manual entry – use file6xKF860fest.TXT which may
be found at ftp://ftp.eaw.com/PPSTfiles/KF860.
• For ECORE – use file 6xKF860fest.EAC which may be
found at ftp://ftp.eaw.com/Process/MX8600
Advertisement
