Table of Contents
Advertisement
Viewing Trouble Conditions
The control panel continuously monitors a number of possible trouble conditions. If one of these
trouble conditions occur, the keypad will beep twice every 10 seconds until you press any key on the
keypad.
NOTE: A TROUBLE condition reduces the security your system is designed to provide. Call your
installing company for service.
To view troubles from an LED Keypad:
A trouble will be indicated by the Trouble light which will remain ON until the trouble condition is
cleared. If you cannot determine the cause of the trouble condition, contact your installer for
assistance.
To view the type of trouble condition, press [ ][2]. A one or more zone lights will turn ON, indicating
the various trouble conditions:
ZONE LIGHT
TYPE OF TROUBLE
1 ................. Service required. Call your installation company for service.
2 ................. Indicates the loss of AC power. When this trouble occurs, the Trouble light will turn
ON but keypad buzzer will not sound.
3 ................. Telephone line trouble.
4 ................. The panel has failed to communicate with the central station.
5 ................. Zone fault. Press [5] and the zone light(s) corresponding to the faulted zones will turn ON.
6 ................. Zone tamper. Press [6] and the zone light(s) corresponding to the tampered zones will
turn ON.
7 ................. Low zone battery. Press [7] and the numbers corresponding to the zones with
battery trouble will turn ON.
8 ................. Loss of time on system clock. To set the system time, following the instructions in
"Setting System Date and Time" on page 12.
To view troubles from an LCD Keypad:
From the Ready state, use the arrow (< >) keys to scroll to the following message.
Press [ ] [2] key to view the trouble. The message will read...
System Trouble
(*2) to View <>
Use the arrow (< >) keys to view which troubles are present on the system. Once
View Trouble <>
you have scrolled through the list of troubles, this display will read...
"Trouble Message"
Press the [#] key to exit the Trouble Viewing mode and return to the Ready state.
11
Advertisement
Table of Contents
