Remote Control Replacement - Dimplex CS3311 Service Manual

CAUTION: Use caution when removing the bottom pan
as the Heater Assembly is attached to it and is wired to
the stove.
9. On the underside of the stove interior, disconnect the
three (3) wires from the Terminal Block that lead to the
Flicker Motor (Figure 8).
Figure 8
Terminal Block
Capacitor
10. From inside the stove, pull the three (3) wires
disconnected in step 9 up through the stove (wires may
be encased in a sheath).
11. Remove the rubber sleeve from the Flicker Motor shaft.
12. Gently bend the Flicker Motor Bracket inwards enough
so that the two (2) screws that mount the motor to the
bracket are accessible (Figure 9).
Figure 9
Flicker
Motor
Flicker Motor
Bracket
Shown exploded for clarity
13. Remove the Flicker Motor by removing the two (2) Philips
screws on either side of the motor.
14. Discard motor.
15. Properly orientate replacement motor and attach to
Flicker Motor Bracket with screws removed in step 13.
16. Gently bend the Flicker Motor Bracket back into its
original position and feed the new motor's wires through
the sheet metal to the Terminal Block.
17. Connect the three (3) wires from the new motor to the
Terminal Block as they originally were (refer to Figure 8).
All wires lead to
Flicker Motor
Black wire
White wire
Brown wire
Wires leading
to Terminal
Block
18. Follow steps 1 through 8 in reverse order to reassemble
the stove.

Remote Control Replacement

Remote Control hand held transmitters require no
replacement procedure however, a reinitialization procedure
may need to be followed. Refer to Page 3 for the procedure.
If the stove was operating prior to servicing allow at least
10 minutes for light bulbs and heating element to cool off to
avoid accidental burning of skin.
Disconnect power before attempting any maintenance or
cleaning to reduce the risk of electric shock or damage to
persons.
Receiver Replacement Procedure:
1. Open stove door.
2. Remove the 11 Philips screws that attach the top panel to
the stove as shown in Figure 4 (page 6). There are: four
(4) screws along each side; and three (3) screws at the
front, accessible behind the door.
3. Remove top panel.
4. Slide mirror up from within the stove to remove.
5. The Remote Control Receiver board is attached to the
back panel of the stove by four (4) Mounting Studs
(Figure 10).
Figure 10
Mounting
Studs (4)
6. Disconnect all five (5) wire clips from the Remote Control
board, noting their original locations.
7. Depress the clasp of each Mounting Stud and release the
Remote Control board from the sheet metal.
8. Properly orientate the replacement Remote Control board
and snap it into place on the four (4) Mounting Studs.
9. Using Figure 10 as a reference, reconnect the five (5)
wire clips disconnected in step 6.
10. Follow steps 1 through 4 in revers order to reassemble
the stove.
8
Black wire to
base of stove
Blue wire to
thermostat
Grey wire to
White wire to
heater switch
base of stove
Brown
wire to
Main
Switch