Volvo C70 Owner's Manual page 186

2. Detach the decal for maximum permitted
speed and affix it to the steering wheel.
WARNING
The sealing fluid can irritate the skin. In the
case of contact with skin, wash away the
fluid with soap and water.
3. Check that the switch is in position 0 and
locate the cable and the air hose.
NOTE
Do not break the bottle seal. The seal is bro-
ken when the bottle is screwed in.
4. Unscrew the orange cap and unscrew the
bottle's stopper.
WARNING
Do not unscrew the bottle, it is equipped
with a reverse catch to prevent leakage.
5. Screw the bottle into its holder.
6. Unscrew the wheel's dust cap and screw
in the air hose valve connection to the bot-
tom of the thread on the tyre's air valve.
WARNING
Do not leave children in the car without
supervision when the engine is running.
7. Plug the cable into the 12 V socket and
start the car.
WARNING
Never stand next to the tyre when the com-
pressor is operating. If cracks or uneven-
ness arise then the compressor must be
switched off immediately. The journey
should not continue. Contacting an author-
ised tyre centre is recommended.
NOTE
When the compressor starts, the pressure
can increase up to 6 bar but the pressure
drops after approximately 30 seconds.
8. Flick the switch to position I.
IMPORTANT
Risk of overheating. The compressor must
not run for more than 10 minutes.
9. Inflate the tyre for 7 minutes.
07 Wheels and tyres
Emergency puncture repair*
WARNING
If the pressure is below 1.8 bar then the hole
in the tyre is too big. The journey should not
continue. Contacting an authorised tyre
centre is recommended.
10. Switch off the compressor to check the
pressure on the pressure gauge. Minimum
pressure is 1.8 bar and maximum is
3.5 bar.
11. Switch off the compressor and unplug the
cable from the 12 V socket.
12. Detach the hose from the tyre valve and fit
the valve cap.
13. As soon as possible, drive approximately 3
km at a maximum speed of 80 km/h so that
the sealing fluid can seal the tyre.
Rechecking the repair and pressure
1. Reconnect the equipment.
2. Read the tyre pressure on the pressure
gauge.
3. If it is below 1.3 bar then the tyre is insuf-
ficiently sealed. The journey should not be
continued. Contact a tyre centre.
4. If the tyre pressure is higher than 1.3 bar,
the tyre must be inflated to the pressure
*
Option/accessory, for more information, see Introduction.
07
185