Chapter 5 Using Your Hdtv For The First Time; Select Input Source; Watching A Tv Program - Vizio VA26L HDTV10T User Manual

Chapter 5 Using your HDTV for the first time

Select Input Source

Select the input source for your HDTV by pressing the INPUT button on
the remote control or the side of your TV. Pressing this button will cycle
you through the following options: DTV/TV, AV, COMPONENT, HDMI 1,
HDMI 2, RGB, and PHOTO.
Turn on your device and you will see a picture on your HDTV. If there is
no picture, make sure you have selected the correct input on your HDTV.
Note: If the selected device is RF connected, your HDTV needs to be in
TV mode and on either channel 3 or channel 4 matching the channel
which has been selected on the back of the VCR, Cable Box, External TV
Tuner or Satellite Receiver. Please refer to the User's Manual of the
respective equipment for details.

Watching a TV Program

Before you start watching TV, please make sure that any cable, satellite or off-air antenna connections
are secure. Also, verify that the AC power cord is plugged into a correctly grounded electrical outlet or
surge protector.
1. Press the power button on the remote control.
2. Select the input to which your device is connected that provides TV programming (e.g. TV, HDMI,
COMP).
Note: You should be able to see a picture. If you do not, make sure that all of your HDTV connections
are secure and you have selected the correct video input source. Each press of the INPUT button on the
remote control will cycle through the available inputs. Press the button until the input associated with the
device you want to view is shown.
3. When using the TV input, press the channel buttons on the remote control or the CH ▲ or ▼
buttons to change the channel. The Channel buttons and on the remote, control will not work if
you are watching a program using HDMI, Component, or AV ( Composite video) inputs.
Version 4/23/2010 15
www.VIZIO.com
VIZIO VA26L HDTV10T User Manual