Hardware Installation; Removing The Dome Cover - Vivotek FD8151V Quick Installation Manual

3

Hardware Installation

Removing the Dome Cover

1. Unscrew the anit-tamper screws using the
included screwdriver.
2. Remove the dome cover.
3. Remove the slide cover if you want to route
cables from the side of camera instead of a
hole on the ceiling or wall.
IMPORTANT:
1. Record the MAC address before installing
the camera.
FD8151V-F2
0002D10766AD
type of lens mounted on your camera. The
applicable lens can be:
F2: 2.4mm; F4: 4mm; F8: 8mm. The shorter
the focal length, the wider the view.
NOTE:
1. It is recommended to use an Ethernet cable that
comes without the strain relief boot. You can
remove the boot if your cable comes with one.
Strain relief boot
2. As shown below, you may also route cable from
the side.
EN - 3