NEC PowerMate SPB-Wash User Manual page 186

Message
Cause
Solution
Message
Cause
Solution
Message
Cause
Solution
Message
Cause
Solution
Message
Cause
C-10 System Board, Connectors, and Error Messages
System CMOS Checksum bad – run SETUP.
System CMOS has been corrupted or modified
incorrectly, perhaps by an application program that
changes data stored in CMOS.
Run the Setup Utility program and reconfigure the
system, either by selecting the default values and/or
by making your own selections.
Monitor type does not match CMOS – Run SETUP.
The monitor type is not correctly identified in the
Setup program.
Run the Setup Program.
Operating System not found.
The operating system cannot be found in either Drive
A or Drive C.
Run the Setup program and make sure the fixed disk
and drive A are properly identified.
Press <F1> to resume, <F2> to enter SETUP.
Displayed after any recoverable error message.
Press <F1> to start the boot process, or <F2> to
enter the Setup Utility program and change any
settings.
Parity Check 1.
Parity error found in the system bus. BIOS attempts
to locate the address and display it on the screen. If
it cannot locate the address, it displays ????.