Table of Contents
Advertisement
5.
Replace the system unit cover (see "Replacing the
System Unit Cover" in Chapter 5).
6.
Connect system power cables and monitor.
7.
Power on the system. The system lets you boot your
computer.
8.
Power off, unplug the system and monitor, and remove
the cover.
9.
Remove the jumper block from pins 25-27 and replace it
on pins 27-29.
10.
If you removed any expansion boards, replace them
(see "Replacing Expansion Boards" in Chapter 5).
11.
Replace the system unit cover.
12.
Power on the system.
Run Setup to set a new password (see Chapter 4, NEC
13.
Drivers and Utilities).
6-12 Setting System Board Jumpers
Advertisement
Table of Contents
