Wall Charger; Charging The Battery - Vertu Ascent Ti RM-267V Quick Manual

Do not drop, knock or shake. Rough handling can break fine mechanics
>
Do not store in hot areas. High temperatures can shorten the life of electronic
>
devices and damage batteries
Do not store in cold areas
>
Do not use harsh chemicals, cleaning solvents or strong detergents to clean
>
Do not paint
>
These suggestions apply equally to your device, battery, charger, or any
enhancement. If any device is not working properly, take it to the nearest
authorised service facility for service.

Wall charger

The wall charger supplied with your Vertu phone can be used in Japan.
Before you plug it in, make sure that the electrical rating of the AC outlet is
appropriate for the charger.
Warning: Never attempt to use a damaged charger. When you
need to replace the wall charger, please contact Vertu Customer
Service at 03-6738-3955 (+81-3-6738-3955 from countries outside
Japan).

Charging the battery

The battery for your Vertu phone is rechargeable and requires charging at
regular intervals.
Warning: Only use the approved charger and battery designed
specifically for your Vertu phone.
Important: If the battery has not been used for some time, you may
need to recondition it by charging it. Although the charging indicator
appears on the display after a few seconds, it may take from several
minutes to an hour before you can make a call.
The charging time will vary with different power sources and we
recommend the Vertu wall charger should always be used.
Always charge the battery until it is fully charged. When the battery is fully
charged, the battery charge indicator stops animating and, if your Vertu
phone is switched on, a "Battery full. Save energy and remove charger
from wall socket." confirmation message is briefly displayed.
If your Vertu phone is not charging, try the following:
Disconnect the charger from the AC outlet.
>
Check that the electrical rating of the AC outlet is compatible with your charger.
>
Verify that the AC outlet has power and that it is switched on. For example, in
>
many hotel rooms, AC outlets are used for lighting and may be switched on and
off from remote locations in the room.
Wait for at least 10 seconds and then reconnect the charger to the AC outlet.
>
Use another nearby AC outlet that you know is providing power.
>
Using your Vertu phone
Insert the charger connector into the
bottom of your Vertu phone as shown.
Please ensure that the connector is
inserted correctly, with the connector
symbol uppermost.
Connect the charger body to a powered
AC outlet.
After a few seconds, the battery indicator
animates and a confirmation message is
displayed if your Vertu phone is switched
on.
35