Basic Operation - Teac Esoteric G-0Rb Owner's Manual

2 5
1
Turn the G-0Rb on.
Display and indicators on the front panel light up.
2
Press the MASTER button to select which oscillator you
will use for the reference frequency.
Rb:
Select this to use the internal rubidium oscillator as the
source clock.
Ext:
Select this to use the input from the reference sourced
10MHz IN terminal
10

Basic Operation

1
3 4
3 Select the appropriate frequency mode using the
FREQUENCY MODE button.
44.1kHz:
Select this for playback of CD, Super Audio CD, etc.
48kHz:
Select this for playback of DVD, DAT, etc.
PAL FILM:
This is used for reproducing PAL DVD discs at 24 frames/sec.
< When only using the UNIVERSAL CLOCK OUT terminal, either
44.1 kHz or 48 kHz may be selected.
< Before you set PAL FILM mode, confirm that the connected
unit can be synchronized with the frequency of PAL FILM.
4
If your units are connected to the WORD SYNC OUT
terminals, select the frequency of the word clock for
each line by pressing the A, B or C button.
< Set the frequency as high as the connected units will allow for
synchronization.
Note:
Select 44.1 kHz for the P-0 or P-0s.
Select 88.2 kHz for the P-70.
5 If your units are connected to the UNIVERSAL CLOCK
OUT terminals, press the UNIVERSAL CLOCK OUT button
to turn it on.
"100 kHz" lights when you set the master mode to 44.1kHz
or 48kHz. "96 kHz" lights when you set the master mode to
PAL FILM.