Setup; Setting Up The Power Supply - Steinberg R 824 Getting Started Manual

Setup

Setup
1. Setting up the
Power Supply
Connecting the AC Power
Adaptor
1.
Insert the plug of the AC power
adaptor into the DC IN 16V jack
on the device.
To prevent accidental unplugging
of the cable during operation,
wrap the cable of AC power
adaptor around the cable clip.
2.
Insert the plug of the power
cable into the AC power adaptor.
3.
Insert the plug of the power
cable into the proper AC outlet
on the wall.
WARNING
Only use the included AC power
adaptor (or an equivalent
recommended by Yamaha). Using the
wrong adaptor can result in damage
to the device or overheating.
12 UR824 Getting Started
CAUTION
Remove the electric plug from the
outlet when the device is not be
used for extended periods of time, or
during electrical storms.
NOTICE
To avoid generating unwanted noise,
•
make sure there is adequate distance
between the power adaptor and the
device.
Avoid tightening the cord more than
•
necessary or pulling on the cord
strongly while it is wrapped around
the cable clip, in order to prevent
wear on the cord or possible
breakage of the clip.
Turning the Power On
AC outlet
and Off
Power on
Press the power button ( ). The power
button will light.
Power off
Hold down the power button ( ) for
over one second. The power button will
light dimly.
The device is equipped with an
automatic power off function. When
this function is enabled, the power of
the device will turn off automatically
(after thirty minutes) when one of the
following actions is performed. The
power button will flash during the thirty-
minute interval.
Turning off the computer.
•