Using The Device Without A Computer - Steinberg UR 824 Operation Manual

Operation
1.
Connect the optical output terminal (ADAT)
of the mic preamp to the OPTICAL A IN on
the device.
2.
Connect the WCLK OUT on the device to the
word clock input terminal on the mic
preamp.
3.
Switch the clock source in the device to
"Internal" by using the following window.
Windows
"(device name) Window" (page 7) in the
section "Control Panel of the Audio Driver."
Mac
Audio MIDI Setup
4.
Switch the clock source of the mic preamp
to the word clock input terminal.
For switching the clock source of the mic
preamp, refer to the owner's manual of your
particular mic preamp.
5.
Switch the DIGITAL MODE of the OPTICAL A
on the device to the "ADAT" by using the
"Setup Window" (page 12) in the section
"dspMixFx UR824" or the "Settings
Window" (page 18) in the section
"Dedicated Windows for Cubase Series."
The operation is now complete.
Using the Device Without a
Computer
This section shows how to use the device without a
computer, allowing you to use it as a standalone
mixer or A/D - D/A converter. You can save the DSP
mixer and DSP effect settings configured by the
dspMixFx UR824 to the device. These settings are
maintained even if you turn off the power of the
device.
Connection Example
Monitor speakers
Guitar Bass
Procedures
1.
Connect the device to a computer with a
USB cable.
2.
Turn on the device.
3.
Open the dspMixFx UR824.
For instructions on opening the dspMixFx
UR824, refer to the "How to Open the Window"
(page 9) in the section "dspMixFx UR824."
4.
Configure the DSP mixer and DSP effect
settings.
5.
When you make the settings, click [X] on the
upper left of the window to close the
dspMixFx UR824.
The settings of the dspMixFx UR824 are saved
to the device.
The operation is now complete.
Usage Examples
Synthesizer
Microphone
Operation Manual
UR824
25