Plugging In The Fortigate - Fortinet FortiGate 3600A Installation Manual

Plugging in the FortiGate

Plugging in the FortiGate
16
The following photos illustrate how the mounting brackets and FortiGate unit
should be attached to the rack.
Figure 2: Mounting in a rack
The FortiGate unit does not have an on/off switch.
To power on the FortiGate unit
1 Connect the power cables to the power connections on the back of the FortiGate
unit.
2 Connect the power cables to power outlets.
Each power cable should be connected to a different power source. If one power
source fails, the other may still be operative.
After a few seconds, SYSTEM STARTING appears on the LCD. The main menu
setting appears on the LCD when the system is running.
The FortiGate unit starts and the Power and Status LEDs light up. The Status
LEDs flash while the FortiGate unit starts up, and remain lit when the system is
running.
Note: If only one power supply is connected, an audible alarm sounds to indicate a failed
power supply. Press the red alarm cancel button on the rear panel next to the power supply
to stop the alarm.
FortiGate-3600A FortiOS 3.0 MR6 Install Guide
01-30006-0457-20080318
Installing