Hardware Installation - AOpen AOW-216 User Manual

between the transmit and receive nodes to guarantee
against all possible packet loss.
NWay Auto-negotiation for any port.
Flow control for any port. This minimizes dropped packets
by sending out collision signals when the receiving buffer is
full. Note that flow control is only available in half-duplex
mode.
Data forwarding rate per port is at wire-speed for 100Mbps
speed.
Data forwarding rate per port is at wire-speed for 10Mbps
speed.
Up to 16K active MAC address entry table with self-
learning and table-aging for 16-port model(AOW-216), up
to 24K active MAC address entry table with self-learning
and table-aging for 24-port model(AOW-224).
1 MB RAM buffer per device for 16-port model(AOW-216),
and 1.5MB RAM buffer per device for 24-port model(AOW-
224)
H
ARDWARE INSTALLATION
The site where you install the hub stack may greatly affect its
performance. Before installing your switch, consider the
following suggestions:
Install the stack in a fairly cool and dry place. See the
4