Figure 3
RS-232/422 connector
pinouts
Caution
Static electricity can damage
electronic circuitry. Before
handling the card, discharge
any accumulated static elec-
tricity from your body by
touching a grounded metal
object.
AXC-MSE Mouse Card
Pre-Installation and Installation
Settings
Pre-Installation
Configure the card
Configuration consists of wiring the RS-232/422 connection correctly. The 8-
position dip switch located on the card is not used.
Pinouts
Figure 3 lists the RS-232/422 connector pinouts.
RS-232/422 connector pinouts
Pin
Signal
1
RS-232 GND
2
RS-232 RXD
3
RS-232 TXD
4
+12V
5-9
Not used
10
RS-232 CTS
11
RS-232 RTS
12 - 16
Not used
Installation
To install the AXC-MSE in a Panja CardFrame, follow these steps:
1.
Hold the card by the tab end and slide the card into the frame, into one of the
slots. Make sure the card is correctly positioned in the guide slot.
2.
Gently push the card in until it is firmly seated in the card connector slot. You
do not have to disconnect the power to the CardFrame when you install the
card. When power is applied to the card, the LED will come on.
Description
Ground
Receive data
Transmit data
Power
N/A
Clear-to-send
Ready-to-send
N/A
Pre-Installation and Installation Settings
3