Table of Contents
Advertisement
Overview and General Specifications
Front View
The enclosure, which is the structural basis of the Epica DGX 16 and 32 Distribution Matrices, can be
controlled using the standard front control panel, control software, or an external controller (for
additional information on control options, see page 15 and for control panel operation, see page 57). The
Power LED indicates the status of the power supplies.
FIG. 1
Front view of an Epica DGX 32 enclosure
Power LED on Front of Enclosure
The Power LED indicates the power status of the redundant power system within the
Epica DGX 16 and 32 enclosure as follows:
Rear View
The enclosure's appearance, as viewed from the rear, will vary depending on the number and types of
input and output boards present. The Epica DGX 16 enclosure in FIG. 2 is fully loaded for 16x16
switching. The Epica DGX 32 enclosure in FIG. 3 is partially loaded for 28x28 switching.
Epica DGX 16
Serial number
FIG. 2
Rear view of a full Epica DGX 16 enclosure
10
LCD
Control Dial
Control Keys
Green – both power supplies are powered on
Red – one of the power supplies is not receiving power or has failed
Off – both power supplies are not receiving power
Input boards (up to 4)
CPU/Control board
Input Keys
Power Indicator
Output Keys
Output boards (up to 4)
Power supplies
Epica DGX 16 and Epica DGX 32 Instruction Manual
Note: Empty input or output
board slots (which are
numbered for expansion)
can be used to upgrade
system.
Advertisement
Table of Contents
