Access Points - Nokia N73 User Manual

Access points

You may receive access point settings in a message from a
service provider. See
access points may be preset for your device by your service
provider or network operator, and you may not be able to
change, create, edit, or remove them.
protected access point, and
access point.
To create a new access point, select
point. Select Use default settings
access point settings, or
existing access point as the basis for the new access point.
To edit the settings of an access point, select
Edit. Follow the instructions from your service provider.
Connection name—Enter a descriptive name for the
connection.
Data bearer—Select the data connection type.
Depending on the data connection you select, only certain
setting fields are available. Fill in all fields marked with
Must be defined
left empty, unless you have been instructed otherwise by
your service provider.
To be able to use a data connection, the network service
provider must support this feature, and if necessary,
activate it for your SIM card.
102
"Data and settings", p. 56. Some or all
indicates a
indicates a packet data
Options
to use the default
Use existing settings
or with a red asterisk. Other fields can be
Copyright © 2006 Nokia. All rights reserved.
Packet data
Follow the instructions from your service provider.
Access point
from your network operator or service provider.
User name—The user name may be needed to make a data
connection, and is usually provided by the service provider.
Prompt password—If you must enter the password every
time you log in to a server, or if you do not want to save
> New access
your password in the device, select Yes.
to select an
Password—A password may be needed to make a data
connection, and is usually provided by the service provider.
Options >
Authentication—Select
Homepage—Depending on the access point you are setting
up, enter the Web address or the address of the multimedia
messaging center.
Select Options
following settings:
Network
IPv4 or IPv6. The other settings depend on the selected
network type.
Phone IP address
your device.
DNS address—In
address of the primary DNS server. In
name—You obtain the access point name
Normal or Secure.
> Advanced settings
type—Select the Internet protocol type to use:
(for IPv4 only)—Enter the IP address of
Primary DNS address, enter the IP
to change the
Secondary DNS