Operation Of Projector; Operation Of Projector By Remote Controller - Mitsubishi Electric PJLink FD630U User Manual

5. Operation of projector

5.1. Operation of projector by remote controller

Group or single unit of projector can be operated.
(1) Select the projector which you like to operate from the projector list on the main screen.
• When selecting more than one projector simultaneously, select while pressing the Ctrl key.
(2) Click [Remote Controller] of the tool bar on the main screen or when you like to operate a
certain projector, double click the projector on the projector list on the main screen.
• "Remote Controller" window is displayed.
(3) Operate the projector by selecting each operating button on the window.
Command
Power
Input Source
Exit
*1
DIGITAL 1 and DIGITAL 2 are HDMI or DVI active. See your projector User Manual for more information.
<Note>
• The next operation can not be performed until the previous operation has been completed.
• The operation can not be performed during re-obtaining (refreshing) the projector status.
• Available input sources vary depending on the type of projectors. You cannot select input sources that aren't
supported by the projector.
Button Description
Power ON Turn on the power supply of the projector.
Power OFF Turn off the power supply of the projector.
COMPUTER 1 Change the input signal to COMPUTER 1.
COMPUTER 2 Change the input signal to COMPUTER 2.
VIDEO Change the input signal to VIDEO.
S-VIDEO Change the input signal to S-VIDEO.
*1
DIGITAL 1 Change the input signal to DIGITAL 1
*1
DIGITAL 2 Change the input signal to DIGITAL 2
NETWORK Change the input signal to NETWORK.
Close the Remote Controller window.
14
*1
.
*1
.