Related Manuals for Miele G 349 Plus
Summary of Contents for Miele G 349 Plus
-
Page 1: Installation Instructions
Installation instructions for eye-level dishwashers It is to read the operating and installation instructions before installing or using the machine, to avoid the risk of accident or damage to the machine. M.-Nr. 05 585 961... - Page 2 These installation instructions apply to several different dishwasher models. Model numbers in this booklet refer to the model designation specified on the data plate on the machine (and not the description on the control panel). The data plate is located at the top of the door when open. The model numbers quoted refer only to the basic model number, e.g.
- Page 3 ............4 1.
- Page 4 This dishwasher is intended to be built To ensure stability this dish- into a tall unit. washer must only be built into a tall The following are needed: unit. It must not be set up as a free- – A facia panel (GW...), standing machine.
- Page 5 Normally connection to water is sited near the dishwasher, for example in the area under the sink. A Miele sink base unit already has a suitable cut out for installation. If the base unit has no cut-out and if there is no opening through the plinth area for connections, one must be made.
- Page 6 The dishwasher must not be used until the control panel has been correctly fit- ted. (G 349) ^ Attach cap a to push button switch. ^ Place the facia panel c in position and use the six screws d to secure ^ Push the ventilation grille b into posi- in place through from the inside of tion so that the slats on the grille are...
- Page 7 (G 396) ^ Attach cap a to push button switch. ^ Place the facia panel c in position and use the six screws d to secure ^ Push the ventilation grille b into posi- in place through from the inside of tion so that the slats on the grille are the door.
- Page 8 ^ Hang the panel front into the slits on ^ Adjust the machine feet evenly until the machine door outer panel a. the height of the dishwasher just reaches the height of the recess. ^ Tighten fixing screws b on both ^ Press the slides with the ratchet at sides of the door outer panel.
- Page 9 The drain hose is in the wash cabinet. The connection stub is located low down on the rear side of the dish- washer. ^ Connect the drain hose using the hose clip supplied. The connection stub can be turned. The hose can be laid to the right or left without needing to loosen the hose clip.
- Page 11 Counter sunk screws 4 x 15 Top frame strip Spacer for unit wall thickness 16 mm Spacer for unit wall thickness 19 mm Side frame strips Foot holds Stoppers Bottom frame strip Spacer bar Plinth facia Plinth facia retainer Rubber rings Protective sheet Wood screws 4 x 20 Wood screws 4 x 15...
- Page 12 ^ Secure the edge protector to the front edge of the unit floor using two 3.5 x 9.5 mm flat head screws. This protects the front edge of the unit base when fitting or removing the dishwasher. ^ Seal the cracks between the side walls and the recess floor and any unprotected cut surfaces with the sili- With a recess width of 562 mm (unit...
- Page 13 ^ Place side frame strips (5) into the ^ Screw the side frame strips to the housing unit A. bottom of the side walls using the 4 x 20 (14) wood screws. ^ Push the top frame strip (2) into position B.
- Page 14 ^ Shut the dishwasher door. ^ Screw the machine feet out until the dishwasher is touching the recess ceiling. ^ Lay the hoses and cable into the unit and down through the installation duct. ^ Push the dishwasher into the unit re- ^ Use a Torx T20 screwdriver to adjust cess.
- Page 15 ^ Open the dishwasher door. ^ Adjust the front screw feet manually or with a flat blade screwdriver. ^ Align the dishwasher: ^ Screw a 4 x 15 (15) wood screw from below into the holes in the right and - the gap between the panel front left hand side of the upper strip.
- Page 16 ^ Remove the backing from the adhesive strip. ^ Put the cover caps back in the open- ings. Use the extra ones supplied if necessary. ^ Stick the protective sheet (13) on the plinth along the edge below the screws.
- Page 17 ^ Fit stoppers (7) into the "Key-holes" in Recess height 876 mm: the side frame strips A. ^ Push the bottom frame strip (8) over ^ Pull the handle for the plinth facia the lower ends of the side frame strips (5).
- Page 18 ^ Half open the dishwasher door. The door springs are correctly adjusted The door springs are easier to adjust when the door remains stationary when when the door is only half open than left open at 45 °. when it is fully open. If the door drops down, then the door springs need to be tightened.
- Page 19 All electrical work should be carried complete connection box and cable out only by a suitably qualified and by a Miele approved service techni- competent person, in strict accor- cian only. dance with national and local safety regulations.
- Page 20 The wires in the mains lead are col- oured in accordance with the following code: Green/yellow = earth Blue = neutral Brown = live If the colours of the wires in the mains lead of this appliance do not corre- spond with the coloured markings iden- tifying the terminals of your plug, pro- ceed as follows:...
- Page 21 (see "Problem solving guide" in the be ordered from the Miele Spare Parts Operating Instruction booklet). Dept. (Part No. 04 274 820). If the water pressure is too high, a pressure reducer valve must be fit- ted.
- Page 22 ^ Open the dishwasher door fully. – The machine drainage system is fit- ted with a non-return valve, which If the site drain connection is situated prevents dirty water from flowing lower than the guide path for the bot- back into the machine via the drain tom basket rollers in the open door the hose.
- Page 23 Height 84.2 cm 84.2 cm (adjustable + 5.0 cm) (adjustable + 5.0 cm) Height of building in recess 87.5 - 89.5 cm 87.5 - 89.5 cm Width 54.7 cm 54.7 cm Width of building in recess 56.2 - 56.8 cm 56.2 - 56.8 cm Depth 57 cm...
- Page 24 Alteration rights reserved (MNovoplus55) / 1003 M.-Nr. 05 585 961 / V00 This paper consists of cellulose which has been bleached without the use of chlorine.