Before Using The Appliance For The First Time You Require; To Call Up The Water Hardness Level In The Display - Miele G 1542 Operating Instructions Manual

Before using the appliance for
the first time you require:
– Approx. 1 kg dishwasher salt*,
– Domestic dishwasher detergent*,
– Rinse aid* formulated for domestic
dishwashers.
* Miele branded products are
available from the Miele Spare Parts
Department or via the internet at
www.miele-shop.com.
Every dishwasher is tested at the
factory.
There will be residual water in the
appliance from this test. It is not an
indication that it has been used
previously.
This dishwasher is fitted with a water
softener sensor which automatically
sets the water softener unit for the
local water hardness level.
Before using for the first time
To call up the water hardness
level in the display
After your dishwasher has been
through one programme cycle, you can
check the water hardness level
measured by the water softener sensor
in the display.
This is shown in °d - German scale, and
can fluctuate depending on the quality
of the water.
^ Switch the dishwasher off using the
On/Off button K.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the the On/Off
button K.
Keep the Start/Stop button pressed in
until the Start/Stop indicator comes
on.
If this does not happen, start the
procedure from the beginning again.
^ Press the Delay start button six times.
The Delay start indicator will flash
briefly six times at intervals.
The number after the p in the display is
the water hardness level in °d.
^ Switch the dishwasher off using the
On/Off button K.
15