Switching A Cooking Zone Off Automatically; Switching Between Timer Functions - Miele KM 490 Operating Instructions Manual

Timer
Switching a cooking zone off
automatically
It is only possible to switch a cooking
zone off automatically if a power setting
has already been selected for that
zone.
Proceed as follows:
^ Select a power setting for the
relevant zone e.g. rear right, in the
usual way.
^ Touch the m sensor.
An indicator lamp will appear in the
timer display.
^ If several cooking zones are being
used, touch the m sensor repeatedly
until the indicator lamp comes on
next to the cooking zone you wish to
use this function for, e.g. rear right.
Each time the m sensor is touched the
indicator lamps will appear one after
the other clockwise from front left to
front right, however only for those zones
which are switched on.
^ Touch - or + sensor.
00 will appear in the timer display.
^ Touch - or + until the time you require
appears in the display, e.g.
15 minutes.
30
The time then counts down in minutes.
The time remaining can be seen in the
display and changed at any time by
touching - or +. The cooking zone
power setting can also be changed at
any time.
At the end of the time set, the cooking
zone will switch itself off automatically.
0 will appear in the cooking zone
display, and 00 in the time display. An
audible tone will sound for approx. 30
seconds at the same time. 00 will go
out when the audible tone stops. To turn
the audible tone off before this, touch
the m sensor.
Switching between timer
functions
If you are already using the timer for
one function and you also wish to use
the other function, touch the m sensor.
The timer display will go out. Now
proceed as before.
To check the remaining time of the
function not displayed, touch the m
sensor once.