1
1-10 Connecting to the Network
!
10/100BaseT Ethernet (RJ-45)
Dongle
Token Ring
Connecting network cable to the Fiery
In this section, the back panel of the Fiery is illustrated, followed by information for
connecting to the Ethernet board. For information about connecting to a Token Ring
network, see
Appendix
A.
Shut down the Fiery before attaching it to any network device. If the Fiery has just
finished processing, wait five seconds after the system reaches the Idle state before using
the power switch to turn it off. For the proper shutdown procedure, see
Back view of the Fiery
page
7-11.