Installation; Unpacking The Transmitter; Mounting The Transmitter; Gas Connections - Teledyne Insta-Trans Operating Instructions Manual

Trace Oxygen Transmitter

Installation

Installation of the Insta-Trans Transmitter includes:

Unpacking

Mounting


Gas connections


Electrical connections

Installing the Micro-fuel Cell

Testing the system.

3.1 Unpacking the Transmitter

The transmitter is shipped with all the materials you need to install
and prepare the system for operation. Carefully unpack the transmitter
and inspect it for damage. Immediately report any damage to the
shipping agent.

3.2 Mounting the Transmitter

The Insta-Trans is intended for indoor or outdoor use.
The Insta-Trans transmitter is provided with a wall mount bracket.
Refer to Figure 3-1 for mounting information and dimensions. The
display and operator control switches are located on the top of the
transmitter. This should be taken into consideration when determining
mounting location. Mount the transmitter with the sensor housing
vertical and the cell holder on the bottom.
3.3 Gas Connections
The unit is manufactured with 1/8 inch tube fittings (consult
factory for other sizes). For a safe connection:
Teledyne Analytical Instruments
Installation
13