Mitsubishi Electric DLP UD8850U User Manual page 40

Menu operation (continued)
ITEM
ASPECT
USER
CLAMP POSITION
CLAMP WIDTH
VERT. SYNC.
LPF
SHUTTER(U)
SHUTTER(L)
SHUTTER(LS)
SHUTTER(RS)
• Though horizontal strips may appear on the enlarged projected image, such symptom is not a malfunction.
• When you change the horizontal or vertical position to a large extent, noise may appear.
• The adjustable range of the vertical position varies depending on the type of the input signal. Though the image may stay in the
same position even when the setting value is changed, such symptom is not a malfunction.
• When you increase the setting value of OVER SCAN, noise may appear on the screen.
• When 16:9 is selected by SCREEN, you cannot set ASPECT to 16:9.
• ASPECT-USER setting supports the COMPUTER1, COMPUTER2, DVI, and HDMI terminals only. Therefore, you cannot select
USER for other terminals.
• See pages 47 and 48 for the detailed setting procedure.
Important:
• You can set the IMAGE menu and the SIGNAL menu only when the signal is supplied.
SETTING FUNCTION
NORMAL Input video signal is displayed at the max height (1200 pixels) or max width
(1920 pixels) of the panel while its aspect ratio is maintained.
• When SCREEN is 16:9, the input video signal is displayed at the max
height (1080 pixels) or max width (1920 pixels) of the panel.
• When SCREEN is 4:3, the input video signal is displayed at the max
height (1200 pixels) or max width (1600 pixels) of the panel.
16:9 Regardless of the type of input signal, image is displayed at 16:9 aspect ratio.
Select to expand squeezed (or horizontally compressed) images such as DVD
images to 16:9.
NATIVE Input video signal is displayed at its original pixel size.
FULL Select to project images in full size (1920 x 1200 pixels) irrespective of type of
input signal.
• When SCREEN is 16:9, images are displayed at 1920x1080 pixels.
• When SCREEN is 4:3, images are displayed at 1600x1200 pixels.
USER Displays the detailed settings. (See page 45.)
ENTER The USER menu is displayed for the following adjustments.
1-255 Use to correct solid white or solid black in the projected image.
1-63 Use to correct solid black in the projected image.
AUTO / OFF Use to adjust the image when its motion doesn't run smoothly. Select AUTO
for normal use.
ON / OFF Use to select whether or not to enable the LPF. (See page 48.)
0-259 Use to adjust the image when noise appears on the top part of the image.
0-259 Use to adjust the image when noise appears on the bottom part of the image.
0-311 Use to adjust the image when noise appears on the left half of the image.
0-311 Use to adjust the image when noise appears on the right half of the image.
EN-40