Mitsubishi Electric DLP HC7900DW User Manual page 23

Viewing computer images (continued)
C. Projecting images
Preparation:
• Remove the lens cap.
• Turn on the power of the connected computer.
POWER indicator
HDMI/COMPUTER button
1. Confirm the POWER indicator lights-up red.
• If the projector was turned off before the lamp had cooled down sufficiently, the fan may start rotating and the
POWER button may not work after the power cord is plugged. (The STATUS indicator blinks green.) After the
fan stops rotating, press the POWER button to turn back on the POWER indicator.
2. Press the POWER button on the projector or ON ( I ) button on the remote control.
• It may take about one minute for the lamp to light up.
• The lamp fails to light up on rare occasions. In such a case, wait for a few minutes and then try again.
• Do not cover the lens with the lens cap while the lamp is on.
• After the POWER button is pressed, the image may flicker before the lamp becomes stable. This is not a
product malfunction.
• The STANDARD lamp mode is activated by default whenever the projector is turned on. When the LOW LAMP
MODE has been chosen, the default STANDARD lamp mode is switched to the LOW lamp mode in 1 minute.
• The projector starts warming up when the POWER button is pressed. During the warm-up process, images
may appear dark and no commands are accepted.
• By blinking red, the STATUS indicator indicates that the lamp should be replaced soon. Replace the lamp when
the STATUS indicator blinks red. (See page 51.)
3. Adjust the focus by turning the focus ring.
• You are recommended to adjust the focus at the screen center.
4. Select an input source.
• Press the HDMI/COMPUTER button on the projector or the COMPUTER/COMPONENT button on the remote
control to select COMPUTER.
• The input source is switched between COMPUTER, HDMI1 and HDMI2 every time you press the HDMI/
COMPUTER button on the projector.
• The input source is switched between COMPUTER and COMPONENT every time you press the COMPUTER/
COMPONENT button on the remote control.
• Though it may take some time before an image is displayed on the screen depending on the type of the input
signal, such symptom is not a malfunction.
• Images may not be projected in the correct position, depending on the type of the input signal. In such a case,
press the AUTO POSITION button. (See page 24.)
• The projector automatically selects the appropriate signal format. (The selected signal format is displayed on
the INFORMATION menu.)
• You cannot change the input source while the menu is being displayed.
• When COMPUTER is chosen as the source, images supplied from the computer may flicker. Press the t or u
button on the remote control to reduce flicker, if it occurs. (Fine adjustment)
5. Adjust the position of the projector to keep an appropriate projection distance with which images are projected in
their specified sizes.
6. Adjust the position of the projector so that the projector and the screen are perpendicular to each other. (See page
10.)
• When the projector cannot be positioned perpendicularly to the screen, adjust the projection angle. (See page 12.)
7. Adjust the image size by turning the zoom ring.
8. Adjust the vertical position of the displayed image by turning the LENS SHIFT dial.
If necessary, adjust the focus and zoom again.
POWER button
STATUS indicator
ON ( I ) button
EN-23
COMPUTER/
COMPONENT button
t, u buttons