Table of Contents
Advertisement
The processor monitors the DVI input and output status and provides the following
information on the front panel display:
Display
Explanation
DVI
Input signal is supported
NO INPUT
No signal is detected.
DVI PASS-THROUGH
A VESA rate has been detected and sent to the output
unprocessed.
RATE NOT SUPPORTED
A VESA or non-video rate has been detected but the selected
output is analogue RGB or YPrPb.
The input type is auto-detected. Supported video rates for processing are 480i/480p,
576i/576p, and 720p/1080i at 50Hz or 60Hz. VESA rates, including 1080p signals, are sent
to PASS-THROUGH only.
To select the DVI input
• Press DVI on the remote control.
To display the signal without processing
• Press Bypass on the remote control.
A DVI cable must be connected from the processor to the display and the digital output
must be activated in the processor SETUP menu.
With HDCP encrypted sources, it may take up to 15 seconds for the HDCP authorisation
between source and display to be acquired. The display device must be HDCP compatible
to view an image. If a switcher is used, it must also be HDCP compliant. HDCP acquisition
problems may be displayed as snow or a flashing image on the screen.
The DVI input levels and sync type must be matched to the DVI source in the SETUP menu.
See Configuring the digital video processor , page 17, for details.
Some DVD players may offer a better image using the analogue YPrPb connections with the
player set to 480i/576i output. This allows the DVP1080HD to do all the deinterlacing and
digital conversion.
To connect two or more HDMI or DVI sources
DVP1080HD Digital Video processor
HDMI to
DVI cable
HDMAX 421
HDMI OUT
4
3
2
1
G91A DVD Player
HDMI OUT
The Meridian HDMAX 421 allows you to connect up to four HDMI or DVI video sources
to a single HDMI or DVI input. In addition, when a Meridian DVD Player is used as the
controller, the HDMAX 421 automatically selects the appropriate video input corresponding
to the currently selected source.
• Connect the output of the HDMAX 421 to the DVI input of the DVP1080HD using an
HDMI to DVI cable.
• Connect the HDMI out from the G Series DVD Player to HDMI input 4 on the HDMAX
421.
• Connect up to three other HDMI or DVI video sources to HDMI inputs 1 to 3 on the
HDMAX 421.
• In the G Series DVD Player HDMI Options screen set the HDMI Switch option to On.
I n s t a l l i n g t h e
d i g i t a l v i d e o
p r o c e s s o r
Satellite receiver
HDMI OUT
Advertisement
Table of Contents
