Table of Contents
Advertisement
BATTERY CHARGING
E
Connector
GAP
INCORRECT
• Plug the battery connector into the charger connector
Push firmly to make sure the connectors are completely joined.
• Plug the charger into a standard wall outlet
Notes:
- Use the charger only in a wall outlet. Do not plug the AC
adaptor into a ceiling outlet.
- If power flow to the wall outlet is controlled by a switch, make
sure the switch is "ON".
- The power indicator on the charger does not indicate the
charge status of your battery. The power indicator allows you
to see that there is power from the wall outlet.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of your
vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the battery connector
from the charger connector. Unplug the charger from the wall
outlet. The battery is now ready to be installed in your vehicle.
Please see the Battery Installation section on page 20 for detailed
instructions on installing your battery. If your battery is already
installed in your vehicle, simply re-connect the motor harness
connector to the battery connector.
P5064pr-0920
Power
Indicator
A
Battery
Charger
Connector
NO GAP
CORRECT
B
.
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
B
not handle parts, including the battery, or
help in assembly of the vehicle.
A
.
1
• Place a .437 cap nut on a flat surface, inside up.
• Fit the end of the rear axle into the cap nut.
• Tap the opposite end of the rear axle with a hammer to secure
the cap nut on the rear axle. Pull on the cap nut to be sure
it's secure.
ASSEMBLY
WARNING
Rear Axle
.437 Cap Nut
F
9
P5064-0920
Advertisement
Table of Contents
