To Set A Clean Cycle - Maytag 336125 Use And Care Manual

TO SET A CLEAN CYCLE
The sell-cleaning cycle IS preprogrammed for 3'12 hours You can also set
the electronic range control for a delayed start of the clean cycle
3 Slide Ihe door handle left lo unlock Ihe door You WIII not be able lo
unlock Ihe oven unless the oven lemperalure IS at a sale level Never
lorce Ihe door IocWunlock handle
To self clean:
1 Slide the door lock hahdfe to the nght. You may need to press the
door slightly to gel it to lock properly.
Never try to force the door lock handle Forcing Ihe handle may
damage the door locking mechanism
2 Push CLEAN button The oven beglns IO heal within 2 seconds
Note- You can find oul when the clean cycle wtll be fInIshed by pushing
the STOP TIME button
To use delayed self-clean:
1 Push STOP TIME bution
2 Turn SET knob to time of day when you wish cleaning to be completed
(must be more than 3'/2 hours later than current time of day)
3 Slide the door lock han$le to the right. You may need to press the
door slightly lo get it to lock properly. Never try to force the door
lock handle. Forcing the handle may damage the door lockmg
mechanism.
4
Push CLEAN bulton.
Note: During a delayed self~clean operation you can find out when the
oven turns on by pushing and holding the CLEAN button
z
TO STOP A CLEAN CYCLE:
m 1
Press the OVEN/CANCEL butlon
P
2 Walt until the oven has cooled below the locking temperature (20-30
minutes) and the word LOCK IS off In the Electronic Range Control
s
display
1
0 13
WHEN A CLEAN CYCLE IS FINISHED
1
Wail unlll the oven has cooled below locking lemperature (20 30
minutes) and the word LOCK IS off in Ihe Electronic Range Control
display
2 Slide Ihe door lockfhandle leh lo unlock the door You WIII not be able
lo unlock the oven unless lhe oven temperature IS al a safe level Never
force the door lock handle
Note- If rhe door does not unlock because the temperature has not had
[Ime IO drop to a safe level when you fIrsI Iry lo open the door be sure
to slide the door lock/unlock handle back all Ihe way IO the right
AFTER A CLEAN CYCLE
After a clean cycle you may notice some white ash in Ihe oven JUSI wipe
II UD with a damp cloth
If whtte spots remain, remove them with a soap-fllled steel wool pad Be
sure to rtnse thoroughly These deposits are usually a salt residue that can
not be removed by the clean cycle. If the oven IS not clean after one clean
cycle, the cycle may be repeated