Line Out Xlr Connections Diagram; Specification - Marshall Amplification JCM 2000 TSL100 Handbook

Diagram E - Line Out XLR Connections
3 3
A 2 2
1 1
2 Core Screened Balanced Mic Lead
3 3
B
2 2
1 1
Unbalanced XLR to Jack Screened Lead
3 3
C
2 2
NC
1 1
Unbalanced XLR to Jack Screened Lead

SPECIFICATION

Output power
Mains input
Mains power input
Mains fuse
HT fuse
Valve (Tube) complement
WARNING : RISK OF HAZARDOUS ENERGY!
!
AVIS : ENERGIE ELECTRIQUE DANGEREUSE!
NC
(typical) 120 watts at 5% THD into 4/8/16 ohms.
117V ~ 60Hz or 230V ~ 50Hz (standard) - others to special order.
(To alter amplifier for different mains voltage specification to that delivered (i.e. 120V to 230V etc), please
contact your country's Marshall distributor or main service centre.)
375 watts.
T4A - 117V or T2A - 230V
T1A
4 x ECC83 (12AX7) - preamp and phase splitter (inverter).
4 x EL34 - output. Marshall - Svetlana fitted as standard.
Jack Plug
Jack Plug
WARNING!
If the loudspeaker is disconnected a high voltage can be present at these
output terminals. Operation in this manner can damage your amplifier,
therefore ensure that the loudspeaker is properly connected.
5
3 3
XLR Channel Input On Mixer
2 2
(Note: Line Level-Approx OdBV)
1 1
Line Level Jack Input On Mixer Etc.
Low Level Jack Input On Mixer (ie Mic Input)