Coaxial Cable - Sharp JW-20FL5 User Manual

M6 bolts 141
Installation of a tap in the main case of a transceiver
Transceiver (tap type)
To connect a tap type transceiver to a coaxial cable, make a hole in the coaxial cable insulation and
insert a probe that will make contact with center conductor in the coaxial cable. Remove the insula-
tion around the coaxial cable using a special tool.
Supply power from a node to the transceiver (12 VDC) using a transceiver cable. Some nodes may
require a separate 12 VDC power supply in order to use the transceiver cable. For details, see the
hardware manual for your node.
The "SQE" switch setting on a transceiver is made as follows.
1. ON when connected to a node.
2. OFF when connected to a repeater.

Coaxial cable

Transceiver cable
(AUI cable)
Transceiver
12 VDC
external
power
supply
Transceiver (tap type) for Ethernet cable
15-31
Tap connector
LAN transceiver
AUI connector
D-sub 15-pin
When using an AUI external
power input terminal block
12 VDC (depends on the
model used)
Chapter 15: Appendix
15