The Akurate Music Server contains an automatic internal mains voltage switch. This switch operates on all worldwide mains voltages from 100 V In order for the NAS to operate with the Akurate Music Server the to 240 V. Manual adjustment on the product for setting the input mains following configurations must be done.
Page 3
Com 1 & 2 For connection to a Linn Kivor Linnk*, PC or third-party control * If you wish to use your Akurate Music Server in a Linn Knekt system, device (see Getting Started guide) the unit must be connected to a Linn Kivor Linnk.
In the event that the unit does not power up when connected to the mains supply, use a pin, straightened paper-clip or a similar implement to With the Akurate Music Server turned off, connect it via a hub/ press the power button, which is located behind the hole in the left-hand router to the installation PC* and the NAS.
Page 5
Linntek to control the unit without making any 15. Press ‘q’ to quit. changes. However, if you wish to use Com 2 on the Akurate Music Server, do the following: 16. The Akurate Music Server will reboot. This will take a few minutes.
Select the desired mode and enter the necessary Internet settings. • Click OK. If you are using an Ethernet connection the Akurate Music Server can be further configured to automatically access the Gracenote CDDB Service when a disc is inserted.
The content of this document is furnished for information only, is subject to change without notice, and should not be construed as a commitment by Linn Products Limited. Linn Products Limited assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual.