Sears 7600058 Manual

!
DO NOT attempt any adjustments, maintenance, repairs, or service with engine running. Stop engine. Engage
parking brake. Remove key. Remove spark plug wire and secure wire away from spark plug. Engine, muffler and
surrounding areas are extremely hot. Avoid serious burns; allow components to cool down before installing kit.
Replace worn or damaged parts prior to operating. Use approved fuel container. DO NOT smoke near open fuel
container. DO NOT fill fuel tank indoors or when engine is running. Allow engine to cool for at least ten minutes
before refilling. Make sure that fuel cap is tightened securely. Wipe off any spilled fuel before starting engine.
7027266 - 7/16-20 x 3 Hex Head Cap Screw (1)
7101716 - Engine Pulley (1)
7101717 - Clutch Retainer (1)
STEP 1: Lower the mowing deck to its lowest cutting posi-
tion. Refer to the unit's Operator's Manual for instructions.
STEP 2: Remove the mowing deck belt from the electric
clutch pulley. Refer to the unit's Operator's Manual for
instructions.
STEP 3: Carefully cut the wire tie securing the electric clutch
harness to the clutch retainer. Then disconnect the electric
clutch harness from the unit's main electric harness. See
Figure 1.
STEP 4: Remove the hardware securing the electric clutch
to the engine shaft. Remove the clutch and clutch key from
the engine shaft. See Figure 1.
Remove hardware and clutch
STEP 5: Remove the forward end of the transmission idler
spring from the shoulder bolt mounted to the underside of
the unit. See Figure 2.
STEP 6: Remove the transmission belt from the engine
pulley and the two transmission pulleys. See Figure 3.
Note: The transmission belt is retained in the idler assembly
by the idler belt guide, and therefore cannot be removed
from the idler assembly at this time.
#7600058 TRANSMISSION PULLEY KIT FOR
SEARS / SIMPLICITY ZT RIDING MOWERS
Kit Contents - 7600058 Transmission Pulley Kit
Disconnect harness
FIGURE 1
WARNING
1732224 - Transmission Belt (1)
7072080 - Wire Tie (1)
Remove idler spring end
STEP 7: Remove the engine pulley assembly from the
engine shaft, and replace with the engine pulley assembly
supplied with this kit. See Figure 3.
Remove
belt
INSTRUCTION No. 7101803 (I.R. 10/31/2007)
1
FIGURE 2
Replace with
supplied
engine pulley
FIGURE 3
TP 200-5303-IR-AT-SC
!