Seagate Barracuda ATA Family Installation Manual page 11

Barracuda ATA Family Installation Guide, Rev. A
Note. You can mount the drive in any orientation. Usually it is
mounted with the circuit board down.
Caution. Do not overtighten the screws or use metric
!
screws. This may damage the drive.
Figure 3. Mounting the drive
3. Secure the drive in the computer using four 6-32 UNC
mounting screws in either the side-mounting or bottom-
mounting holes. Insert the screws no more than 0.22 inch
(5.58 mm) into the bottom-mounting holes and no more than
0.20 inch (5.0 mm) into the side-mounting holes.
7