Input Modes - Kenwood VR-4700 Connection Manual

How Do I Adjust the Sound?

Input Modes:

The listen mode should usually be set to Full Auto. However, the listen
mode can also be set manually when you want to fix the inputs as analog
signals, etc. (see "To Set the Input Mode manually" on page 22).
FULL AUTO
(Full Auto)
DIGITAL-AUTO
(Dig.Auto)
DIGITAL-MANUAL : The inputs are fixed at digital signals and the listen
(Dig.Manual)
ANALOG
(Analog2ch)
6CH INPUT
(Analog6ch)
• If you turn off the receiver or select a different source device the DIGI-
TAL-AUTO or DIGITAL-MANUAL is reset to "FULL AUTO".
• When you use DIGITAL-AUTO or FULL AUTO mode with certain
DVD and LD players, performing operations such as "Skip" or "Stop"
may momentarily interrupt the output. This could switch the "Listen
Mode" automatically to the surround mode intended for the input
signal if you have manually selected a different listen mode.
: The receiver detects the input signal format auto-
matically and switches itself accordingly. Usually
select this mode.
: The inputs are fixed at digital signals and the listen
modes are switched automatically.
modes should be switched manually by the user.
The DIGITAL-AUTO and DIGITAL-MANUAL
modes are switched automatically to the FULL
AUTO mode when an input is switched or the re-
ceiver is set to OFF.
: The inputs are fixed at the analog 2-channel inputs.
: The inputs are fixed at the analog 6-channel inputs.
This mode can be selected only when the DVD in-
put is selected with the input selector.
21