Lvlnboot(1M) - HP -UX 11i Administrator's Manual

Max PE per PV
VGDA
PE Size (Mbytes)
Total PE
Alloc PE
Free PE
Total PVG
Total Spare PVs
Total Spare PVs in use
VG Version
VG Max Size
VG Max Extents
In this example, the total free space is 600 physical extents of 4 MB, or 2400 MB.
2. The logical volume is mirrored with a strict allocation policy, and there are not enough extents
on a separate disk to comply with the allocation policy. To confirm this, run lvdisplay to
determine which disks the logical volume occupies, and then check whether there is sufficient
space on the other disks in the volume group.
3. In a SAN environment, one of the disks was dynamically increased in size. LVM did not detect
the asynchronous change in size.
Recommended Action
1. Choose a smaller size for the logical volume, or add more disk space to the volume group.
2. Choose a smaller size for the logical volume, or add more disk space to the volume group.
Alternatively, free up space on an available disk using pvmove.
3. Use the vgmodify command to detect the disk size change and incorporate the new space
into the volume group.
Message Text
"m": Illegal option.
Cause
The system does not have HP MirrorDisk/UX installed.
Recommended Action
Install HP MirrorDisk/UX.

lvlnboot(1M)

Message Text
lvlnboot: Unable to configure swap logical volume.
Swap logical volume size beyond the IODC max address.
Cause
The boot disk firmware cannot access the entire range of the swap logical volume. This happens
with older host bus adapters when primary swap is configured past 4 GB on the disk.
Recommended Action
Upgrade the system firmware or use a newer host bus adapter that supports block addressing. If
neither of these actions succeeds, reduce the size of the primary swap logical volume so that it
does not exceed 4 GB.
4350
2
4
4340
3740
600
0
0
0
1.0
1082g
69248
lvlnboot(1M) 165