Removal And Replacement Of Evaporator Assembly - Hoshizaki F-1001MAH Service Manual

8. Removal and Replacement of Evaporator Assembly

1) Turn off the power supply.
2) Remove the panels.
3) Move the flush switch to the "FLUSH" position.
4) Turn on the power supply and drain out all water from the water line.
5) Turn off the power supply.
6) Remove the strap connecting the spout to the chute assembly.
7) Remove the five thumbscrews and lift off the spout.
Cutter
8) Remove the bolt and lift off the cutter.
9) Remove the Rubber O-ring and the Nylon Ring at the top of the Evaporator.
Extruding Head
10) Remove the four socket head cap screws and lift off the extruding head.
11) Replace the bearing inside the extruding head, if it exceeds the wear tolerance of 0.02"
or is scratched.
Note: Replacing the bearing requires a bearing press adaptor. If it is not available,
replace the whole extruding head.
Auger
12) Lift off the auger. If the area in contact with the bearing is worn out or the blade scratched,
replace the auger.
Evaporator
Note: Skip the following steps 13) through 15) when the evaporator does not need
replacement.
63