Advertisement
REQUIRED, NOT SUPPLIED:
Ramsey case, knob and panel set, Ramsey part no. CQRP
Matching input and output cables to existing QRP transmitter
12 volt DC power supply 3 amp rating
Proper dummy load or resonant antenna
"THE RAMSEY LEARN-AS-YOU-BUILD ASSEMBLY STRATEGY"
Take a look at the parts layout diagram. There is quite a lot to the construction
of the QAMP20. It's easier than it seems once you get going, especially after
you have installed a few of the "landmark" components. Once these "landmark"
components are placed, other parts' positions are referenced to them, and
construction goes quite smoothly. This will help in relating from one part to
another what specific holes it may require on the board, and that part's
orientation. In addition, we will discuss the purpose of most components or
groups of components as we go along. This is the Ramsey Learn-As-You-Build
kit assembly philosophy. Be sure to read through all the steps, and check the
boxes as you go to be sure you didn't miss any important steps. Most of the
problems we find here at the factory are due to faulty assembly, no matter how
experienced the builder may be: it's especially tough to tell a 30 year
experienced ham that he goofed! Before you run the circuit, check all diodes
and polarized capacitors for proper orientation.
TIPS AND NOTES:
Use a good soldering technique - let your soldering iron tip gently heat the
traces to which you are soldering. Heat both wires and pads simultaneously.
Apply the solder on the iron, lead, and the pad when pad and wire is hot enough
to melt the solder. The actual joint should look like a drop of water on paper
(somewhat soaked in).
Parts are mounted on the top side of the board. This is the side that has no
traces or pads on it.
Part orientation - All parts in this kit are mounted at 90 degree angles, meaning
parts are either parallel or perpendicular to the sides of the board.
Part installation - When parts are installed, the part is placed flat to the board,
and the leads are bent on the backside of the board to prevent the part from
falling out before soldering. The part is then soldered into place, and the spare
leads are removed. Make sure lead lengths are as short as possible when
dealing with the RF section of this kit.
QAMP20 • 6
Advertisement
