Operation - Fujitsu ASU9C1 Operating Manual

OPERATION

To Select Mode Operation
Press the START/STOP button (Fig. 6 ¡).
1
The Indoor Unit's OPERATION Indicator Lamp (red) (Fig.3 5) will light.
The air conditioner will start operation.
Press the MASTER CONTROL button (Fig.6 *) to select
2
the desired mode.
Each time the button is pressed, the mode will change in the following order.
AUTO
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the TEMPERATURE set button.
button: Press to increase the thermostat setting.
button: Press to lower the thermostat setting.
¶ Thermostat setting range:
Cooling/Drying ..................................................... 64°F to 88°F
Fan ......................................................................... 62°F to 88°F
About three seconds later, the entire display will reappear.
NOTE:
¶ The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
¶ During Fan mode, set the unit to "– –" for continuous fan operation regardless
of room temperature.
The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 +).
Each time the button is pressed, the fan speed changes in the following order:
3
AUTO
About three seconds later, the entire display will reappear.
When set to AUTO:
Cooling: As the room temperature approaches that of the thermostat setting, the
fan speed becomes slower.
Fan: The fan will operate at the optimum speed in accordance with the room
temperature in the vicinity of the indoor unit.
When set to QUIET:
SUPER QUIET operation begins. The indoor unit's airflow will be reduced for qui-
eter operation.
¶ SUPER QUIET operation cannot be used during Dry mode. (The same is true
when dry mode is selected during AUTO mode operation.)
¶ Cooling performance will be reduced somewhat during SUPER QUIET opera-
tion.
En-7
COOL FAN
DRY
3 3 3
HIGH LOW
MED
3
QUIET
SLEEP TIMER
COOL
MASTER SET SET FAN
CONTROL TEMP. TIME CONTROL
START/STOP
Example: When set to COOL
SLEEP TIMER
F
MASTER SET SET FAN
CONTROL TEMP. TIME CONTROL
START/STOP
Example: When set to 80°F.
SLEEP TIMER
AUTO
MASTER SET SET FAN
CONTROL TEMP. TIME CONTROL
Example: When set to AUTO.
In order to increase the drying effect
during quiet cooling operation, the fan
of the indoor unit may stop.