When Recording Please Pay Attention To These Points; About The Data Saved Or Recorded By The Customer; Notes For Lcd Screen; To Protect The Lcd Screen - Pioneer AVIC-Z1 Hardware Manual

When recording please pay
attention to these points;
• Pioneer does not compensate for the contents
that could not be recorded or any loss of
recorded data due to a malfunction or failure of
the navigation system.
• The data recorded on the navigation system is
not allowed to be used without a permission
from its right holder under copyright law
except for personal entertainment.
• Make sure to check the recording operation
before recording and check the recorded con-
tents after recording.
• Recording is not guaranteed for all CDs.
About the data saved or
recorded by the customer
• The data saved or recorded onto this naviga-
tion system by the customer cannot be
extracted from the navigation system, and
those service cannot be accepted.
• The data saved or recorded onto this naviga-
tion system by the customer cannot be guaran-
teed during repair or service. Lost data that
was saved or recorded by the customer is not
guaranteed.
• Due to copyrights, the music data recorded
into the Music Library cannot be backed up
during repair or service.

Notes for LCD Screen

To protect the LCD screen

❒ Do not allow direct sunlight to fall on the LCD
screen when this navigation system is not
being used. Extended exposure to direct sun-
light can result in LCD screen malfunction
due to the resulting high temperatures.
❒ When using a cellular phone, keep the
antenna of the cellular phone away from the
display to prevent disruption of the video with
disturbances such as spots or colored stripes.
❒ Never touch the LCD screen with anything
besides your finger when operating the Touch
Panel functions. The LCD screen can scratch
easily. (The stylus is supplied for special cali-
brations. Do not use the stylus for normal
operation.)
8
➲ For details about handing the LCD panel ➞
Page 21

For viewing LCD comfortably

Due to its construction, the viewing angle of the
LCD screen is limited. The viewing angle can be
increased, however, by using [Brightness] to
adjust the black density of the video. When using
for the first time, adjust the black density in
accordance with the viewing angle to adjust for
clear viewing. [Dimmer] can also be used to
adjust the brightness of the LCD screen itself to
suit your personal preference.

Notes for Internal Memory

Before removing the vehicle bat-
tery
If the battery is disconnected or discharged, the
memory will be erased and must be repro-
grammed.
➲ For details, refer to "Returning the Navigation
System to the Default or Factory Settings" in
the the Operation Manual.

Resetting the Microprocessor

• Pressing the RESET button mainly clears
the settings for the AV source without
clearing all the items of navigation func-
tions. Please see section "Returning the
Navigation System to the Default or Fac-
tory Settings" of the Operation Manual
before clearing.
Pressing the RESET button lets you reset the
microprocessor to its initial settings without
changing the condition memory.
➲ Condition Memory ➞ Page 17
The microprocessor must be resetted under the
following conditions:
• Prior to using this navigation system for the
first time after installation.
• If the product fails to operate properly.
• If there appear to be problems with the opera-
tion of the system.