Toshiba HD-A2KU Owner's Manual page 23

Make the necessary setting.
1
Turn on the connected TV and select the input from the player.
2 Press ON/STANDBY to turn on the player (_ page 30).
3 Press SETUP to display "SETUP MENU", if not displayed.
4
Press • / • to select "Picture" then press OK.
5 Press • / • to select "Resolution Setting", then press OK.
6 Press •/• to select the resolution according to the performance of
your TV as shown in the table below.
ONiSTAN DBY
_ _ -- ON/STANDBY
mA/V
OK
-- SETUP
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii!i!iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii i i i!i !ii!
HDM[ iNPUT
Component video
input
S-VIDEO or
_]_ _VlD_ (yellow) input @.
-.":::_4_, VIDEO S-VIDEO
Select "up to 1080i".
I up to 480i I
I up to 480p I
I up to 720p I
Select the resolution according to the performance of the
connected TV.
I
up to 480i
I
[ up to 480i I I up to 480i ]
lupto480p I _ lupto480p I lupt°480p I
lupt°720p I lupto720p I _ lupto720p I
[uptol080i ! luptol080i I [uptol080i I
No need to set.
Refer to the table on the next page for actual resolution of the player par each setting.
• For best output, disc's native resolution is also important. See the note on 0 page 24.
7 Press OK.
8 Press SETUP to turn off "SETUP MENU".
The necessary setting is complete. Now your player is ready. Proceed to _ page 30 to begin your operation.
23